Instructions:
| 1. |
Hold
unit in left or right hand using centre rotating handle(a)
|
| 2. |
Attach
end of material being handled to inner retainer hook(b)
or through either hole(c)
|
| 3. |
Rotate
unit clockwise with other hand using winder knob(d)
until fully installed
|
| 4. |
To
unwind hold rotating handle(a) with left or
right hand and pull on material free end
|
WARNING: Power supply cables must
be fully unwound before use to prevent damage or
fire. |
Comms or Data Cable:
| 1. |
Remove
inner retainer hook(b) to eliminate interference
with cable
|
| 2. |
Pull
2 or 3 metres of cable through either hole (g)
or (c) and wind tightly around face of spool
using cable retainers(e)
|
| 3. |
Attach
free end using any hole(f) at outer rim
|
| 4. |
Wind
cable onto spool as per instructions until desired
capacity reached
|
| 5. |
Retain
free end using any hole(f) at outer rim
|
|
 |
For
the handling of the following Communication or Data Cables: Don
10 cable, WD-1/TT cable, WD-1A/TT cable, WF-16/U cable, WF-8/G
cable, Cat 5 cable, Cat 6 cable, Cat 7 cable, Optical Fibre cable,
Firing cable AWG number 18, Detonator cable, Audio/Video cable,
Microphone cable, Telephone cable, wire, etc
Stacking:
If stacking of units is required, do not fill spool above winder
knob cut out(h)
|
